Escooter tuning dethrottling 35 kmh ESA 5000 and ESA 1919
Tax included.
This tuning chip removes the speed limit of the e-scooter so that it travels between 28 km/h and 35 km/h. Installation is very easy and only takes 5 minutes. The chip only works with the ESA 5000 and ESA 1919 scooters.
more details
After connecting the tuning, you can switch on and use the scooter normally. The tuning only becomes active by pressing the scooter's power button 6 times in a row. Then the scooter travels at 28 km/h to 35 km/h instead of 20 km/h. If you switch off the scooter, the tuning is deactivated again. Every time you switch it on, the scooter is initially in its normal state. The throttle to 20 km/h is active. If you press the power button 6 times quickly, the tuning will of course be activated again until you turn the scooter off. This means you can easily control when the scooter's throttle is active and when it is canceled.
The original speedometer shows the higher speeds correctly.
- Easy installation: The enclosed instructions explain the installation step by step. Installation is very easy and can be completed in 5 minutes. You can't do anything wrong or damage anything.
- Easy to use: After easy installation, the speed limit can be canceled before each trip by pressing the button on the speedometer 6 times. After switching off, the scooter behaves normally again until the tuning is activated again.
- Simply inconspicuous: The tuning does not make any permanent changes to the scooter. You can remove the tuning chip just as quickly and easily as you can install it. After removal, everything on the scooter is in its original condition and the tuning leaves no trace. The chip is not visible from the outside.
The functions and installation of the chip were well documented by the community here in this video: on YouTube ->
| Important Information! |
Not suitable for public transport. The scooter's general operating license expires upon installation.
In the event of an accident, insurance coverage could be affected.
The risk of injury increases when driving at higher speeds. I take no responsibility. Only ride with a helmet and all important protectors. With modification it can only be used as sports equipment. No liability for defects in the sports equipment and no liability for consequential damages from defects in the sports equipment.
The scooters are not designed for speeds of over 20 km/h. Even with a helmet and protective equipment, it is not possible to use it with the same level of safety as in the factory condition. Use at your own risk. Driving at high speeds is dangerous and increases the risk of injury.
The statutory conditions apply to liability for material defects and guarantees.
The 35 kmh is more of a theoretically safe maximum value. The circuit board sends the scooter the command to drive 35 kmh. The scooter then uses 350W power if possible until 35 kmh is reached. But the 350W is often not enough to achieve more than 30 kmh.
Depending on the manufacturing tolerance of the motor and luck, you can achieve more or less speed with the 350W.
The scooter uses the circuit board to achieve the maximum that the hardware allows.
WEEE reg. no. DE 98802828
Information obligations in accordance with Section 18 Paragraph 2 of the Electrical and Electronic Equipment Act: https://www.bmuv.de/themen/wasser-projekte-abfall/kreiswirtschaft/statistics/elektro-und-elektronikaltgeraete |
|---|
